How to Clean Up Jaw Crusher Parts?

How to Clean Up Jaw Crusher Parts?

In order to ensure and prolong the service life of jaw crusher, Some cleanup work is very necessary. Here are two kinds of cleaning methods, manual cleaning and mechanical cleaning.

Manual cleaning

1. The scrub.

Put the jaw crusher parts in the container of diesel, kerosene or other cleaning fluid, and then brush with a hairbrush or scrub with a cotton yarn. It has the features of easy operation and simple equipment, but low efficiency, which issuitable for singleton, small batch and small parts.Gasoline is generally unfavorable because it is fat-soluble, and it can damage people's health and easily cause a fire.

2. Spray cleaning.

Spray the cleaning fluid with a certain pressure and temperature to the parts surface to remove grease. Hongxing Machinery thinks that this method has good effect and high efficiency, which is suitable for spare part whose shape is not too complicated and the surface has serious oil dirty.

Mechanical cleaning

1. Boil to clean.

Put ready-prepared solution and parts together into a washing pool welded by the steel plate, then heat it to 80 ~ 90 ℃, boiling washing 3 ~ 5 min.

2. Vibration cleaning.

Put jaw crusher parts in vibration cleaning basket or the rack, and immerse them in the cleaning fluid for a few minutes, and remove grease through vibration cleaning machine.

3. The ultrasonic cleaning.

Depending on cleaning fluid chemistry with the ultrasonic oscillations by the introduction of the cleaning fluid, to remove grease.